 |
|
| If you can't view the Datasheet, Please click here to try to view without PDF Reader . |
|
|
|
| If you can't view the Datasheet, Please click here to try to view without PDF Reader . |
|
|
| Datasheet File OCR Text: |
| Data Sheet No. PD 10064 revA Series PVN012APbF Microelectronic Power IC HEXFET Power MOSFET Photovoltaic Relay (R) Single Pole, Normally Open, 0-20V, 4.0A AC/ 6.0A DC General Description The PVN012A Series Photovoltaic Relay at 50 milliohms features the lowest possible on-state resistance in a miniature package -- lower than a comparable reed relay. The PVN012A is a single-pole, normally open solidstate relay. It utilizes a HEXFET(R) MOSFET output switch, driven by an integrated circuit photovoltaic generator of novel construction. The output switch is controlled by radiation from a GaAlAs light emitting diode (LED) which is optically isolated from the photovoltaic generator. These units exceed the performance capabilities of electromechanical relays in life, sensitivity, stable onresistance, miniaturization, magnetic insensitivity and ruggedness. They are ideally suited for switching high currents or low level signals without distortion or injection of electrical noise. Series PVN012A relays are packaged in a 6-lead molded DIP package with either thru-hole or surface mount (gull-wing) terminals. They are available in standard plastic shipping tubes or on tapeand-reel. Please refer to part identification information. Features ! ! ! ! ! ! ! ! 50m On-Resistance Bounce-free Operation 4.0 - 6.0 Amp Capacity Linear AC/DC Operation 4,000 VRMS I/O Isolation Solid-State Reliability UL Recognition Pending ESD Tolerance: 4000V Human Body Model 500V Machine Model Applications ! Portable Electronics ! Computers and Peripheral Devices ! Audio Equipment ! Power Supplies and Power Distribution ! Instrumentation Part Identification PVN012APbF PVN012ASPBF PVN012AS-TPbF Thru-hole Surface-mount Surface-mount, tape and reel (HEXFET is the registered trademark for International Rectifier Power MOSFETs) www.irf.com 1 Series PVN012APbF Electrical Specifications (-40C TA +85C unless otherwise specified) INPUT CHARACTERISTICS Minimum Control Current (see figure 1) Maximum Control Current for Off-State Resistance @ TA = +25C Control Current Range (Caution: current limit input LED, see figure 6) Maximum Reverse Voltage Limits 5.0 0.4 5.0 to 25.0 6.0 Units mA mA mA V OUTPUT CHARACTERISTICS Operating Voltage Range Maximum Continuous Load Current @ 40C, 10mA Control (see figure 1) A Connection B Connection C Connection Maximum Pulsed Load Current @ 25C,10mA Control (100 mS @ 10% duty cycle) A Connection B Connection C Connection Typical Thermal Resistance (Tthja, Junction-to-Ambient) A Connection B Connection C Connection Maximum On-State Resistance @25C, 10mA Control 100mA pulsed load, (see figs. 3 & 4) A Connection B Connection C Connection Maximum Off-State Leakage @ TA=+25C, 20VDC Maximum Turn-On Time @TA=+25C (see figure 7), for 1A, 20 VDC load, 10mA Control Maximum Turn-Off Time @TA=+25C (see figure 7), for 1A, 20 VDC load, 10mA Control Typical Output Capacitance @ 20VDC (see figure 2) Limits 0 to 20 4.0 4.5 6.0 8.0 9.0 15.0 85.1 122.9 89.7 50 25 15 1.0 3.0 0.5 400 Units V(DC or AC peak) A (DC or AC) A (DC) A (DC) A (DC or AC) A (DC) A (DC) (oC/W) (oC/W) (oC/W) m m m A ms ms pF GENERAL CHARACTERISTICS Minimum Dielectric Strength, Input-Output Minimum Insulation Resistance, Input-Output Maximum Capacitance, Input-Output, Vd =0V, f = 1MHz Maximum Pin Soldering Temperature Ambient Temperature Range: Limits 4000 1012 1.0 +260 -40 to +85 -40 to +100 Units VRMS pF C Operating Storage International Rectifier does not recommend the use of this product in aerospace, avionics, military or life support applications. Users of this International Rectifier product in such applications assume all risks of such use and indemnify International Rectifier against all damages resulting from such use. www.irf.com 2 Series PVN012APbF Connection Diagrams 5.0 I LED = 10mA "A" Connection 1200 1000 "A" Connection Max. Load Current (A) I LED = 5mA Typical Capacitance (pF) 4.0 800 600 400 200 0 3.0 2.0 1.0 0.0 0 20 40 60 80 100 Ambient Temperature (C) 0 5 10 15 20 VDD Drain to Drain Voltage Figure 1. Current Derating Curves* Figure 2. Typical Output Capacitance * Derating of ` B' and ` C' connections at +85C will be 70% of that specified at +40C and is linear from +40C to +85C. 2.5 250 200 Rd-on (Normalized to 25oC) 150 2 "A" Connection 10mA Control ID = 1A Voltage Drop (mV) 100 50 0 -50 -100 -150 -200 -250 -10 1.5 1 I LED = 10mA 100mS Pulsed, 25C "A" Connection -8 -6 -4 -2 0 2 4 6 8 10 0.5 0 -50 -25 0 25 50 75 100 125 Ambient Temperature (C) Load Current (A) Figure 3. Linearity Characteristics Figure 4. Typical Normalized On-Resistance www.irf.com 3 Series PVN012APbF 100 20 CAUTION:provide current limiting so that 25mA maximum steady state control current rating is not exceeded. 16 Input Current (mA) 10 ID-OFF/ ID-OFF 25 oC 12 Min. device and +85C limit TYPICAL Max.device and -40C limit 8 1 4 0.1 -35 -15 5 25 45 65 85 105 Ambient Temperature (C) 0 0 0.5 1 1.5 2 LED Forward Voltage Drop (V DC) Figure 5. Typical Normalized Off-State Leakage Figure 6. Input Characteristics (Current Controlled) 10 Delay Time (milliseconds) ton ILED 90% 1 tdly 0.1 toff (10mS Pulse Width, 20V/1A Load) ID 10% tdelay ton toff 0.01 5 10 15 LED Current (mA) 20 25 Figure 7. Typical Delay Times Figure 8. Delay Time Definitions www.irf.com 4 Series PVN012APbF Case Outlines 01-2008 01 01-2009 01 IR WORLD HEADQUARTERS: 233 Kansas St., El Segundo, California 90245 Tel: (310) 252-7105 This product has been designed and qualified for the Industrial market Data and specifications subject to change without notice. 9/7/2006 www.irf.com 5 |
Price & Availability of PVN012ASPBF
 |
|
|
|
|
All Rights Reserved © IC-ON-LINE 2003 - 2022 |
| [Add Bookmark] [Contact Us] [Link exchange] [Privacy policy] |
|
Mirror Sites : [www.datasheet.hk]
[www.maxim4u.com] [www.ic-on-line.cn]
[www.ic-on-line.com] [www.ic-on-line.net]
[www.alldatasheet.com.cn]
[www.gdcy.com]
[www.gdcy.net] |